The title says that the whole film is three hours long, because the time is too long, and the baling process has been edited. The whole film also has 61 minutes
I haven't wrapped a mummy for a long time. I have forgotten the tiredness of wrapping a mummy, so I want to practice it again
Because the first few sisters are quite resistant to taped mummies, they feel very afraid of tight bags and sensory deprivation for a long time
So Shiyu confirmed again and again. After getting her consent, she began to work carefully, for fear that she would shout to stop if it hurt
When the weather gets warmer, it's even a little hot, so I suggest that it rain all the time
This time, wrap the human shape before wrapping the human chair, and then put the human shape on the chair and bind it together, so that the body can be integrated into the chair
The whole baling process was very smooth, and there was no accident to worry about. Shi Yu said that she would fall asleep several times in it. It seemed that she was relieved to become a filler
Finally, after two hours, there was a black human-shaped chair in the open room. In addition to seeing her mouth, her whole body was wrapped with tape and tied with the chair, leaving only limited and ineffective little struggle space
First, I took out the tape secretly, approached the figure quietly, and suddenly closed her mouth without warning and covered it tightly with my hand
After being sealed by the fully fitted adhesive tape, the human form will have no air and make a tiny cry for help
After tearing off the tape, the figure will open its mouth and breathe. That's right. Today's project is to misuse your mouth
Mouth ball seems to have little impact on human shape
The opening device is restricted by tape. The whole face of the human figure will be tightened every time the opening device is turned up, and the voice feedback of the human figure can be heard every time the opening device is pressed
The four-way breathing tube changes the direction of breathing in a whim. The front door can be glued to the mouth with adhesive tape. It looks more integrated. It is connected with two thin tubes and glued to the top of the head. There is an alien illusion. The breath tone of the air passing through the thin tubes is higher and better
Breathing tube inflation plug, the product of the last time I played with vacuum bed, has always liked this design, and can also connect the breathing bag
Pinch the inflation valve four or five times for the human figure, listen to her voice getting sharper and sharper, activate the vibration prop stuck in place, connect the breathing bag, and admire her beautiful posture
Three hours later, I saw that the state of the rain was a little low, so I immediately opened it for her
There was sweat all over it. Shi Yu said that he felt thinner
Postscript
Later, I asked Shiyu how she felt. She said that the mouth misuse part was damaged, and there were no other problems. She also said that she could stay longer
One day when I watched Twitter and saw someone challenging ten pieces of ZENTAI, I realized that I had not played multiple layers before, so I opened the cabinet and started plotting
There are 4 pieces that can be used, KIG leather, coated black, black mamba, lycra black, all right, they are black
Due to the fact that both the leather and adhesive black are open mouths, it is necessary to increase the difficulty and flip out the microporous head cover as well
Facing the pile of clothes I took out, Shi Yu thought I was going to take them for dry cleaning. I said no, you have to put them on. Shi Yu looked at me with a look at aliens on his face
I struggled to put on four layers of ZENTAI, and Shi Yu's body grew stronger in a big circle. If I still have to challenge myself in the future, I need to order a looser style
Due to Shi Yu's good performance in the last breathing bag session, we have prepared a lot of breathing exercises this time, including holding and panting categories, and will take turns to play
After wearing the microporous headcover, don't rush to put on the ZENTAI headcover first. Wrap the microporous part of the headcover with cling film, and the latex and cling film materials will automatically stick together, forming a tight fit that limits the entry and exit of breathing air
This state can only rely on the residual air in the lungs and the gaps in the hood to forcefully breathe, and soon the rain waved its hand as a sign that it couldn't hold on
Although the time was short, it was full of enjoyment and I didn't have enough fun doing it again. This time, I tied my head even harder and fixed my head on the pillow. My hands were also fixed, watching her struggle quietly
After playing with the breathing bag twice, I practiced it. In order to reduce air leakage, I made a connection for the breathing bag using a breathing mask and tightly wrapped it on the latex head cover using cling film
This time, the breathing bag can fully inflate, but even with a capacity of 3L, even if it rains heavily, it cannot fully inflate. However, this state is already very satisfactory
This practice lasted for a few minutes, and the grades were fine. Shi Yu was also panting hard enough
But it was all warm-up before, and now I put on the headband layer by layer for her
When putting on the fourth layer of headgear, it feels like the facial contour is completely covered up, resembling a humanoid doll. The exhalation of the rain passes through several layers of fabric, making a sound of airflow and vibration. Each breath requires more force than usual
Take out a 30 * 40 plastic bag, which is usually used to hold props with force, and reluctantly insert it into the bag
The barrier between latex and fabric, as well as the friction and contact of plastic bags, result in heavy breathing and lack of space. Shi Yu said this is the most painful part
But she didn't know there was still heat shrink film, and the space would be further reduced
Omit the introduction of the heat shrink film process and quote a sentence from Shi Yu that says, 'It's more comfortable to feel the pain of fainting.'
Even so, I still used heat shrink film twice on her. I really wanted to ruin her
Joking, not willing to give up
After a break, the sun went down and the room had no external light, and the lighting atmosphere I had set also came out
Replace Shi Yu with an open latex headband, as she will need to rely on biting her mouthpiece to sustain her life
This time it was wrapped in cling film, and the entire headband was wrapped tightly. Then, two layers of ZENTAI headbands were put on. The Lycra black and black Mamba were not opened, so they were simply removed. The exposed adhesive black looked even better in the light
The effect of connecting the breathing tube to the breathing bag is also very good, and the bag shrinks and expands during breathing
It wasn't until Shiyu began begging for mercy that I allowed her to pull out her breathing bag on her own
This time it's time to get started. Despite the already tiring rain, I wrapped her latex headband with cling wrap again
First, let her open her mouth and use a flat part to firmly hold it, then pull harder every turn, causing her face to deform a bit
She only had space to breathe in her open mouth, and the plastic wrap was sucked in and out
Later, in her struggle, she broke free a little bit of the cling film in order to get a hint of air flowing in
How can this work? So I'll do it again right away. This time, I'll wrap it more forcefully and wrap it in more circles, one covering my head
This time, the killing power is strong, and Shi Yu said that this section is almost collapsing. Even calling me did not rescue her, but let her untie it herself
Her untwisting motion was completely messy, and she had to grope for the edge of the cling film while still in a controlled state. In the end, her brain couldn't think, and relying on instinct to help herself, she struggled to untie all the entanglements, spreading out on the chair without saying a word
